PARK TOOL – 1170-2 – CRP-1 CROWN RACE PULLER REPLACEMENT BLADES

The blades of the CRP-1 may be replaced as needed (part #1170-2, two required).

1. Remove the four outer shell bolts and separate the outer shell and the inner shell.
2. Loosen the two inner shell bolts if necessary and remove old blades.
3. Install new blades, with the flat side of the blades facing outward.
4. Secure the two inner shell bolts enough to allow blades to slide easily.
5. Place outer shell over inner shell and re-install and tighten the four outer shell bolts